Refrigerator, dryer and washer repair in Studio City · 91604 · 91602 · open daily 8 AM to 7 PMCall (747) 325-5782
Studio City
Appliance Repair Co.In-home repair, Studio City CA
(747) 325-5782
Home › Guides › Washer won't drain

Washer won't drain: what to check first

Quick answer: most washers that do not drain have a clogged pump filter or a kinked drain hose. Clean the filter (bottom front on most front-loaders), straighten the hose, and run a drain-and-spin cycle. If the pump hums but no water moves, or makes no sound at all, the pump or its wiring needs repair.

Before you start

Unplug the washer. Have towels and a shallow pan ready: a full drum can release a lot of water through the filter.

1. Pump filter

Open the small panel at the bottom front, drain the water through the small hose if there is one, then unscrew the filter slowly. Coins, hair ties, lint and small socks are common finds.

2. Drain hose

Check the hose behind the washer is not kinked or pushed too far into the standpipe, and that the standpipe is not clogged.

3. Run drain and spin

With no clothes, run a drain-and-spin cycle. Listen for the pump.

When to call

See washer repair in Studio City.

← Washer repair

Common questions

Why is there water left in my washer?

Usually a clogged pump filter or a kinked drain hose. A failed drain pump is the next cause.

Can I open the washer door with water inside?

Not safely. Drain the water through the pump filter first; many front-loaders keep the door locked until the water is out.

Appliance down in Studio City?

Call, tell us the brand and what it is doing, and we will set a visit time.

(747) 325-5782
  Call (747) 325-5782