Dryer repair in Studio City
Symptoms and the usual cause
| What you see | Electric dryer | Gas dryer |
|---|---|---|
| Runs, no heat | Thermal fuse, heating element, half of the breaker tripped | Thermal fuse, igniter, gas valve coils, gas supply |
| Heats, but takes two cycles | Restricted vent or crushed hose (most common), weak flame on gas models, failing moisture sensor | |
| Drum does not turn | Broken belt, idler pulley, drive motor | |
| Will not start at all | Door switch, thermal fuse (on many models), start switch, control board | |
| Thumping, squealing | Worn drum rollers, idler pulley, drum glides | |
| Burning smell or shuts off | Lint buildup near the heater, vent restriction, overheating | |
Vents in Studio City homes and apartments
In apartments, dryers often sit in a closet with a short, tight hose that gets crushed when the dryer is pushed back. In houses, the laundry is often in a garage or an inside laundry room, and the vent may run a long way to reach an outside wall or the roof. Every extra foot and every bend gives lint a place to settle. That is why we check airflow at the outside vent on every dryer call. A new part will not last if the vent stays blocked.
Safe checks before you call
- Clean the lint screen; wash it with dish soap if water beads on it.
- Electric dryer with no heat: switch the dryer breaker fully off, then on.
- Gas dryer: make sure the gas valve behind the dryer is open.
- Run the dryer and check the outside vent flap opens with strong, warm air.
- Pull the dryer forward and straighten or replace a crushed hose.
If you smell gas, close the valve, leave and call the gas company. Do not bypass a thermal fuse to make the dryer heat.